[DeTomaso] lower support shaft -again
SOBill at aol.com
SOBill at aol.com
Sun Jul 18 19:39:21 EDT 2010
FWIW,
My OEM lower shafts are exactly 5/8 inches (15.875mm) in diameter. This is
within .00492 inches of 16mm ....... my guess is it is a 16mm shaft.
This means the factory turned the OEM shafts to a smaller diameter to use
a 14mm nut. MAP must also have turned turned some (early) shafts to a
smaller diameter to thread them for a 9/16 nut.
MAP now threads the shaft without reducing the diameter and uses a 5/8-18
nut. This eliminates two turning operations on each shaft and leaves more
meat on the shaft ends for drilling/tapping the zerk fittings.
Have fun now,
SOBill Taylor
sobill at aol.com
More information about the DeTomaso
mailing list