[DeTomaso] Welding question? Stainless with MIG
Ken Green
kenn_green at yahoo.com
Tue Jul 13 16:45:18 EDT 2010
Steve,
You may want to ask the welder if he back-purges the tubes with an inert gas or used a flux (e.g., SolarFlux type B) when he welds stainless. Based on some reading and the Burns Stainless catalog, the welds are a lot stonger if you prevent oxidation on the back side. I have run into some people who just return blank stares when I asked about this, so I guess it is not a universal practice.
Ken
--- On Tue, 7/13/10, steven.liebenow at att.net <steven.liebenow at att.net> wrote:
From: steven.liebenow at att.net <steven.liebenow at att.net>
Subject: [DeTomaso] Welding question? Stainless with MIG
To: "mailing list detomaso" <detomaso at realbig.com>
Date: Tuesday, July 13, 2010, 11:01 AM
Hopefully VERY SOONLY..... I will be needing to fit my new mufflers to a set of
new headers....
I ordered the mufflers with the inlet pipes unwelded, so that I could trim and
weld accordingly.....
My question is this..... Can I use my MIG welder to safely tack the pipes where
they need to be???? I would then drop them back out and take them down to
the welder for proper stainless finishing......
Can anyone chime in on what sorts of issues may arise??
Thanks!
Steve
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list