[DeTomaso] Welding question? Stainless with MIG

[Dave Londry]

Good subject guys.
I need to weld a bleed line into one of my new stainless cooling tubes 
and I wondered what wire to buy.
Now I just need to find some scrap to do a couple of practice welds.
dave



j g wrote:
> you can buy 308 wire for your mig and do it yourself. 
>
> --- On Tue, 7/13/10, steven.liebenow at att.net <steven.liebenow at att.net> wrote:
>
>
> From: steven.liebenow at att.net <steven.liebenow at att.net>
> Subject: [DeTomaso] Welding question? Stainless with MIG
> To: "mailing list detomaso" <detomaso at realbig.com>
> Date: Tuesday, July 13, 2010, 1:01 PM
>
>
> Hopefully VERY SOONLY..... I will be needing to fit my new mufflers to a set of 
> new headers....
>
> I ordered the mufflers with the inlet pipes unwelded, so that I could trim and 
> weld accordingly.....
>
> My question is this.....  Can I use my MIG welder to safely tack the pipes where 
> they need to be????      I would then drop them back out and take them down to 
> the welder for proper stainless finishing......
>
> Can anyone chime in on what sorts of issues may arise??
>
> Thanks!
> Steve
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
>
>