[DeTomaso] Upright Bearings ? Again
B Hower
b.hower3400 at yahoo.com
Tue Jan 26 07:49:35 EST 2010
Bill,
Sorry, I didn't make my self clear here. I'm talking about the suspension portion of the upright where it pivots on a mounting shaft ( 5A844 ) and spacer ( 5A843 ). Not the spacer on the axle between the bearings.
Bud #3400
--- On Tue, 1/26/10, SOBill at aol.com <SOBill at aol.com> wrote:
From: SOBill at aol.com <SOBill at aol.com>
Subject: Re: [DeTomaso] Upright Bearings ? Again
To: b.hower3400 at yahoo.com
Date: Tuesday, January 26, 2010, 6:02 AM
Bud,
I'm not sure I know what you mean about drilling the upright housing and the spacer. The spacer between the bearings rotates with the axle and the inner race of each bearing. Other than a light coating of rust prevention grease during assembly, no lubrication inside the upright housing is needed.
Are referring to grease fittings for the lower pivot shaft of the upright?
Have fun,
SOBill Taylor
sobill at aol.com
In a message dated 1/25/2010 5:33:25 P.M. Pacific Standard Time, b.hower3400 at yahoo.com writes:
Bill,
I ordered 6308-2RS1/C3 SKF at 32.50 each.
And 5208-2RSC3 MRC at 48..20 each.
Plan to order Wilkinson axles at 225.01 each
And cut down the spacers per your measurements.
I will add grease fitting to the upright housing and drill through the spacer so that both inside and outside of spacer gets lube.
And thanks again for your help.
Bud 3400
==============================================================
More information about the DeTomaso
mailing list