[DeTomaso] Epoxy in Injector Pockets????
Ken Green
kenn_green at yahoo.com
Wed Jan 20 17:23:13 EST 2010
Tomas,
I wondered about a press fit and epoxy. I need to understand epoxy better. It seems like a press fit would scrape all the epoxy off the mating surfaces, unless the surfaces have scratches that hold some of the epoxy? Is this an issue or is there a small residue that remains that bonds the parts? I know that it's good to have a minimum amount of glue between surfaces in most instances, but does that extend to press fits?
The holes will be milled not drilled, so they will be a very good fit. But, the injector pockets will not be perpendicular to the roof of the runner, so that may affect a press fit?
Ken
--- On Wed, 1/20/10, Tomas Gunnarsson <guson at home.se> wrote:
From: Tomas Gunnarsson <guson at home.se>
Subject: Re: [DeTomaso] Epoxy in Injector Pockets????
To: detomaso at realbig.com
Date: Wednesday, January 20, 2010, 1:36 PM
I share your feelings regarding epoxying metal to metal in an engine application. How about a loose press fit with the epoxy acting more as a sealant? The loose press fit could be achieved by drilling the holes and/or turning the injector holders to zero press fit, then scarring one of the surfaces for a small interference fit. I haven't seen the parts so I don't know if this is practical though.
Tomas
----- Original Message -----
From: "Ken Green" <kenn_green at yahoo.com>
To: <detomaso at realbig.com>
Sent: Wednesday, January 20, 2010 12:31 AM
Subject: [DeTomaso] Epoxy in Injector Pockets????
> I'm having a manifold converted to EFI and the shop thinks it's better to epoxy the injector pockets into the manifold than to weld them. I bought MSD pockets, and they say "epoxy in" on the label. It's a little scary, but there in no structural issue, and it's not like adding epoxy inside ports that can break loose. Is it a waste of $s to have the pockets welded in?
>
> Ken
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list