[DeTomaso] upright bearing spacer length ?
mikeldrew at aol.com
mikeldrew at aol.com
Thu Jan 14 21:16:48 EST 2010
In a message dated 1/14/10 14 26 23, b.hower3400 at yahoo.com writes:
> Reference your article in PCNC News Volume 36 Issue, 7 July 2009 -- Grin
> and Bearing it. You state that to install the double row bearing you can
> remove .480" from the spacer length. But you also state that the spacer gets
> worn in the bad axle process. My question is how long is a standard spacer?
>
I don't have a stock spacer with me at the moment, but there's one floating
around in the De Tomaso tool kit that I borrowed from Chuck Melton.
Chuck--how about you get your dial calipers out?
The good news is that the actual length of the spacer is very non-critical.
It can probably vary by 1/8 or even 1/4 inch in length and still be
perfectly fine. Much more important is that the face on either end is perfectly
flat.
Mike
More information about the DeTomaso
mailing list