[DeTomaso] Pantera Suspension Rebuild

[Bob Radefeld]

Hey Mike & Mike,
 Was thinking along those lines and your recommendations
will come in handy - Thanks! I know one thing for sure, it
won't take me as long to "finger" out how to get the rear top
A-arm bolt on the right front out of it's seemingly impossible
position. Had to THINK awhile on that one & it HURT my
brain (or what's left of it!).

Bob
  ----- Original Message ----- 
  From: mikeldrew at aol.com 
  To: mbefthomas at comcast.net ; bob at dodgecarroll.com ; detomaso at realbig.com ; cengles at cox.net 
  Sent: Thursday, December 23, 2010 12:13 PM
  Subject: Re: [DeTomaso] Pantera Suspension Rebuild


Mike wrote: >When I put mine on, it was literally a 3 hour job to finish both sides.  All
I did was (in order) unbolt and hang the brake caliper, unbolt the sway bar
end, pop the tie rod end, unbolt the top A arm and the top of the shock, let
the assembly drop down and unbolt the bottom A arm bolts and pull the entire
L or R front suspension assembly away from the car.  Swap the bushings right
there, and reverse the process.  No popping of ball joints and messing with
camber and toe (though you'll need to get an alignment anyway).
 >>>If you already have poly bushings installed, you can do this job in a matter of minutes, not hours.  Just support the spindle/rotor on a jack, unbolt the upper control arm from the chassis, swap the bushings, re-attach them to the car.  Then unbolt the lower control arm from the chassis, swap those bushings, reattach, and drive to your friendly alignment shop. :>)

Mike=