[DeTomaso] water temp sender
JDeRyke at aol.com
JDeRyke at aol.com
Tue Dec 14 00:47:31 EST 2010
In a message dated 12/11/10 11:52:30 AM, larry at ohiotimecorp.com writes:
> That is normal, as you say, but to be the most normal the sender should
> be in the motor block and of course the block needs to be grounded,
> normally.
>
Not only what Chris described with his inadvertant insulating of the surge
tank, but a few owners in the past have used far too much teflon pipe-tape
on the threads going into the block, and then found spotty temp readings due
to partially ungrounding the sender with the thread tape. Two complete turns
on the threads of any pipe fitting is plenty; more sometimes causes
problems. One guy then SOLDERED a ground wire to the brass temp sender body to
solve HIS ground problem! Not too sure what 600F soldering temps might do to a
sender, but it worked for him... FWIW- J DeRyke
More information about the DeTomaso
mailing list