[DeTomaso] Torque question
MikeLDrew at aol.com
MikeLDrew at aol.com
Tue Aug 24 00:51:14 EDT 2010
In a message dated 8/23/10 21 41 26, boyd411 at gmail.com writes:
> I just noticed today while I was switching the the rotor to the new hat
> that
> my allen screws were drilled for safety wire. What do you wire them to? I
> don't see a place to anchor the wire. granted I have never safety wired
> anything before, I have only heard about it on internals of ZF's and seen
> it
> on aircraft. Please elaborate.
>
Normally, you wire adjacent screws to one another, in such a fashion so
that if one were to loosen, it would attempt to tighten the opposite one.
Check out this photo from Wilwood, it shows it perfectly:
http://www.theheadfl.com/pics/wired7.jpg
Mike
More information about the DeTomaso
mailing list