[DeTomaso] Engine Block Heater Tube Fitting Removal
JDeRyke at aol.com
JDeRyke at aol.com
Fri Aug 13 14:50:47 EDT 2010
In a message dated 8/13/10 10:09:50 AM, doug351c at gmail.com writes:
> What's a good way to remove the pressed-in engine block heater tube
> fitting? The engine is not being torn down do I can't let any shavings get into
> the water jacket.
>
The fitting is flimsy sheet metal, usually badly rusted and is only pressed
into an unthreaded hole. The simplest way is to crush it in a big
Vise-grips pliers, then pry on the pliers with a bar through the access cover hole.
On most blocks, you won't even need to remove other parts to access it.
New replacementss are available, or Marlin Jack can machine you a
thick-wall stainless replacement that also drives into the tapered hole and last for
several lifetimes..... No threading needed either way. Cheers- J DeRyke
More information about the DeTomaso
mailing list