[DeTomaso] front hood headlight buckets rubber grommets on 1972 detomaso pantera
MikeLDrew at aol.com
MikeLDrew at aol.com
Sun Aug 1 01:58:48 EDT 2010
In a message dated 7/31/10 9 02 38, LEVITT1946 at aol.com writes:
> The bodyshop had to put washers between the hood and the hinge to keep
> the
> hood from rubbing against the lower lip in front of the car . Is this
> correct to put washers or shims under the hinge ? The washers are under
> the
> hinge where the hinge holds the hood.This cannot be correct. Is there a
> correct way to adjust the hood so that it does not rub the lower left and
> right
> of the hood. Or are the hood hinges bent?
>
>>>Maybe, or maybe the car isn't quite straight. It's not uncommon to use
shims between the underside of the hinges, and the body. Same with the
decklid--I have three big fender washers shimming one of the two decklid
hinges away from the roof. Much easier than trying to bend the hinge.
>
>
> >The passenger side headlight bucket does not seem level .The lower left
> corner of the bucket was sitting slightly up.Is there a trick to
> adjusting?
>
>>>Shim the upper right corner! Same deal--adjusting the headlight
buckets sometimes means using a variety of shims (washers) of different
thicknesses in different corners to get them to both match.
Mike
More information about the DeTomaso
mailing list