[DeTomaso] Pushrod guideplate adjustment
JDeRyke at aol.com
JDeRyke at aol.com
Wed Apr 14 01:10:56 EDT 2010
In a message dated 4/13/10 6:54:55 PM, wkooiman at earthlink.net writes:
> My 2nd guess is you're okay as long as you have enough thread engagement
> and everything is lined up. That's only a guess, though. You want to get
> advice from someone else (not me) on this one.
>
Rule of Thumb is, thread engagement should be a minimum of twice the
diameter of the threaded part plus 2 threads.
Isky and Crane both sell a cheap stud-boss cutter that can be used in a
1/2" hand drill, but one can still bias the cut to one side while doing the
boss trimming, and can overshoot the depth of cut, maybe leading to the varying
thread depths and off-center angles on some rockers. Correcting all this
back to good geometry can be done with shims, but its too bad the correction
must be done at all. Good luck- J DeRyke
More information about the DeTomaso
mailing list