[DeTomaso] Final Turn Signal Lights

[michael@michaelshortt.com]

I decided to remove and polish fronts turn signal lens tonight ( Plasti-X
and a cotton buffing wheel on a bench grinder at low speed )
and discovered that somewhere down the line a previous owner used something
like grout or window pane goo to seal the lens into the reflector body,
what a mess to clean out.  I'm sure there should have been O rings or large
gaskets ( #1660, 1971 ) , can those be purchased and if yes, where?

Thanks

Michael Shortt

-- 







Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you