[DeTomaso] Pushrod guideplate adjustment??
JDeRyke at aol.com
JDeRyke at aol.com
Mon Apr 5 13:45:03 EDT 2010
In a message dated 4/5/10 1:18:52 AM, wkooiman at earthlink.net writes:
> Actually from that picture it looks like something is bent. It shouldn't
> be off by that much.
>
Check everything. All the parts involved- the valve stems, pivot studs, the
rockers, guide plates and pushrods- are hardened steel and cannot be
straightened if even slightly bent. Matter of fact, if anything IS bent, throw it
away before it breaks in two and takes out the top end or worse. It may only
be a matter of visual perspective, but better to spend a couple of hours
checking than find out the hard expensive way. good luck- J DeRyke
More information about the DeTomaso
mailing list