[DeTomaso] Steering Shaft Slip Joint
JDeRyke at aol.com
JDeRyke at aol.com
Thu Apr 1 14:36:10 EDT 2010
In a message dated 3/31/10 1:59:55 PM, tmshinro at aol.com writes:
> I had some slop in my (steering shaft) slip joint and I inserted a brass
> shim in the joint to fill the void. Went to a hobby store to get some
> brass sheet stock of the needed thickness and cut out a piece to fit into the
> joint.
>
Originally, there were two thin nylon shims in there but they didn't last
long. Your fix is a good one, as is squeezing the flat sides in to take up
some of the resulting slack. FWIW- J DeRyke
More information about the DeTomaso
mailing list