[DeTomaso] How easy to pull a ZF vertically using an overhead beam?

[MikeLDrew at aol.com]

In a message dated 9/16/09 12 49 11, kenn_green at yahoo.com writes:


> Is this a one man job with the deck off?
> 
>>>Sure, assuming you have a proper hoist.
>  
> Do the motor mounts alone hold the engine OK with the ZF out?
> 
>>>Yup, no problems there at all.
>  
> The motor and ZF were installed in the body as a convenience, otherwise 
> the engine compartment is empty, no rear window.
>  
> >>>Should be a snap.   You'll have to disconnect the side mount from the 
gearbox and flip them down and out of the way, then the gearbox will have to 
slide back several inches before you can lift it out.

You may find it easier if you loosen the engine mounts and tilt the engine 
slightly forward to improve the departure angle.

Mike