[DeTomaso] correct fluid for clutch master

[michael@michaelshortt.com]

Yes, hopefully that will do it, most of the time, the DOT 5 isn't kind to
Dot 3 immersed Orings, seals, etc.

I'd go buy a BIG bottle of cheap DOT 3 and flush it as long as I could stand
doing it, then install the Dot 4
and hope for the best.


Michael Shortt

On Tue, Sep 15, 2009 at 10:02 AM, <JJD1010 at aol.com> wrote:

>
>
> Ok, so I probably would be best served with DOT 3/4. I am using DOT
> 5(silicone) now and they react badly with each other. What do I need to do
> to
> change over to DOT 3/4? Do I need to flush my system?
>
> Thanks,
>
> Jeff
> 6559
>  _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>



-- 







Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you