[DeTomaso] Fw: Exhaust temps

[gow2 at rc-tech.net]

Yes, I built circuits and wrote a program to read them. Real helpful is
seeing problems I had in a header design.

Gary

> That is exactly what I want to do. I have an IR system and I'm
> concerned about individual cyclinders. Did you use type K thermocouples?
> Will
>
> ----- Original Message -----
> From: "GW" <gow2 at rc-tech.net>
> To: "Will Demelo" <wdemelo at cogeco.ca>
> Cc: <detomaso at realbig.com>
> Sent: Sunday, October 25, 2009 10:25 PM
> Subject: Re: [DeTomaso] Exhaust temps
>
>
>> These temps were collected at about 2500 rpm un loaded. The difference
>> in
>> temps was related to a header imbalance:
>>
>> http://www.rc-tech.net/cars2/ts/egtrun1.jpg
>>
>> http://www.rc-tech.net/cars2/ts/d2.jpg
>>
>> Gary
>>
>>
>>
>> Will Demelo wrote:
>>> If I was to insert a temp probe inside the header tube a few inches
>>> away
>>> from the exhaust port, what kind of temp would I read?
>>> Will
>>> _______________________________________________
>>>
>>> Detomaso Forum Managed by POCA
>>>
>>> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>>>
>>> DeTomaso mailing list
>>> DeTomaso at list.realbig.com
>>> http://list.realbig.com/mailman/listinfo/detomaso
>>>
>>>
>>
>>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>