[DeTomaso] crossmember
Will Demelo
wdemelo at cogeco.ca
Sat Oct 3 10:08:09 EDT 2009
The original crossmamber needs to be cut out. I used a 5" grinder with a
thin cutting disk and then a reciprocating saw with a long metal blade to
get the top side. Wear full goggles.
Will
----- Original Message -----
From: "bill gaino" <gaino at earthlink.net>
To: "detomaso mailing" <detomaso at realbig.com>
Sent: Saturday, October 03, 2009 8:25 AM
Subject: [DeTomaso] crossmember
> My early pushbutton car is scheduled to have an Aviad pan installed. I did
> my research and had everything to make a removeable crossmember. While I
> was under the car removing the suspension, I noticed that the rear
> crossmember is already at the front most lower arm mount bolts, and it is
> welded in like it came that way from factory. Does this mean I don't need
> to relocate? Is it different that later cars? Bill 1362
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list