[DeTomaso] Pulling dash1

[bill gaino]

The needle bearing came out fine, I made a tool to drive grease into the larger bushing that is pressed in the crank, and sticks out. But my hammer just bounces off. Is that adapter just pressed in?
-----Original Message-----
>From: bill gaino <gaino at earthlink.net>
>Sent: Nov 16, 2009 1:39 PM
>To: detomaso mailing <detomaso at realbig.com>
>Subject: [DeTomaso] Pulling dash1
>
>We are doing a dash 1 to dash2 swap today. I already found the dash2 shift shaft is not splinned like my dash 1. Hopefully I can just swap shafts. Looks like it is held in place with 2 set screws accesablbe through holes in the bottom of the shift cover. I have the correct clutch disc 1 1/16 for the dash2. What about pilot bushings?  Any diff? My Ceterforce setup with flywheel only has 3000 miles, I'm only changing the disc. Thoughts welcome.  Bill 1362
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso