[DeTomaso] Rear Bushings and Shafts
JDeRyke at aol.com
JDeRyke at aol.com
Tue Nov 10 16:51:21 EST 2009
In a message dated 11/10/09 12:51:52 PM, richard at hitecheng.on.ca writes:
> ....The bronze bushings were worn paper thin on the top.....
>
And as you likely found, those guys are are real b... to dig out without
damaging the cast iron upright bores. But helpfully, the vendor replacements
I've seen are really simple to press back in, and fit without needing more
'work'. Up-and-down motion and noise back there due to worn rear bushings
allowing the lower a-arm end(s) to shift is sometimes misdiagnosed as worn
wheel bearings, bad u-joints and other more serious maladies, but you gotta be
looking at the right place to see it. Cheers- J Deryke
More information about the DeTomaso
mailing list