[DeTomaso] Bleeders on the heads... need advice before I cry
wkooiman at earthlink.net
wkooiman at earthlink.net
Tue Nov 3 18:22:13 EST 2009
Do it when the engine is really hot. The steam will blow the metal shavings all over your body - but not in the engine.
No really - the standard answer is to pack the drill bit with grease - and go slow. Most of the shavings come out (and not in) anyway.
-----Original Message-----
>From: JJD1010 at aol.com
>Sent: Nov 3, 2009 9:38 AM
>To: detomaso at realbig.com
>Subject: Re: [DeTomaso] Bleeders on the heads... need advice before I cry
>
>
>
>
>In a message dated 11/3/2009 9:11:35 A.M. Central Standard Time,
>red3644 at hotmail.com writes:
>
>No need to pull the engine & heads if you want to try this.
>
>
>
>
>.
>How do you keep metal shavings from getting into the cooling lines while
>you are drilling and tapping the holes?
>
>Thanks,
>
>Jeff
>6559
>
>
>
>
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list