[DeTomaso] Fuel tank threads
Paul - Home
thedrol at pobox.com
Wed May 27 12:34:34 EDT 2009
I thought that the gas tank drain plug was a tapered thread. At least
it is on my late model car. So is there any concerned about using a
straight thread banjo or a straight thread elbow?
Paul
#9270
Doug Braun wrote:
> Will,
>
> The M22 threads are VERY close to 3/4"NPT pipe thread. Then I used a
> NAPA-Weatherhead #3220x12x8 bushing, 3/4" NPT male to 1/2" NPT female.
> Followed by a 1/2' NPT male to 1/2" NPT female brass pipe elbow.
>
> Although at this point I'd have to endorse Dave Nunn's M22 x 1.5 banjo bolt
> and M22 x -10AN male banjo.M22 banjo fitting method over mine.
>
> Doug Braun
> blue 73L #5505
>
> -----Original Message-----
> From: detomaso-bounces at realbig.com
> [mailto:detomaso-bounces at realbig.com]On Behalf Of Will Demelo
> Sent: Tuesday, May 26, 2009 3:36 PM
> To: detomaso at realbig.com
> Subject: [DeTomaso] Fuel tank threads
>
>
> What size threads is the drain plug on a 74? I remember reading that
> although they are metric, they are very close to NPT?
> Will
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
More information about the DeTomaso
mailing list