[DeTomaso] Thermoswitches
Matt
matt at nwpantera.com
Sun May 17 22:29:32 EDT 2009
Thanks Chuck. I was thinking a local parts store(Pep Boys,NAPA,etc.) I did some digging in the archives and someone (I think JDeRyke?) mentioned a water cooled VW cross reference.
Thanks again,
Matt
----- Original Message -----
From: Charles Engles
To: Matt
Cc: detomaso at realbig.com
Sent: Sunday, May 17, 2009 6:36 PM
Subject: Re: [DeTomaso] Thermoswitches
Dear Matt,
Well, to state the obvious: call the Byers boys at Precision ProFormance (?). I would bet that they have what you need in stock *and* it should fit without thrashing. FWIW.
Warmest regards, Chuck Engles
----- Original Message -----
From: "Matt" <matt at nwpantera.com>
To: <detomaso at realbig.com>
Sent: Sunday, May 17, 2009 7:18 PM
Subject: [DeTomaso] Thermoswitches
> Hi gang,
> Pulled my rad today for a small leak repair. Noticed both my thermoswitches are 82c/77c. This translates to 180f/171f.
> The fans seem to come on at too low of a temp not allowing the motor to maintain proper operating temp(195-200?).
> I'd like to install higher degree switches. Anybody know of a good source for these? I have a brass Pro-Performance rad purchased in 1999.
>
> Thank you folks for all your un-ending help and insight,
> Matt
> 3584
> Reno or bust!
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
More information about the DeTomaso
mailing list