[DeTomaso] Help needed with clutch slave
JDeRyke at aol.com
JDeRyke at aol.com
Fri May 8 12:04:46 EDT 2009
In a message dated 5/7/09 9:22:24 PM, chrisvkimball at msn.com writes:
> I just bled my new slave, and when I pushed the clutch down to see if it
> worked, it started to, then fluid shot out of the little valve. I don't
> want to overtighten it and break it off, or is my problem the bleed valve
> just isn't tight enough?
>
.....or that junk from your system is under the pointy end, holding it off
the base of the hole its supposed to seal. It doesn't take a lot of torque
to seal off the bleed-needle but a Crescent wrench is not good enough. I use
a 1/4" drive ratchet and appropriate socket. If the worst happens and
someone does break one off, it can be drilled out. And if you bugger THAT up,
Speedway sells a repair bushing and a new needle for less than $10, but the hole
needs to be tapped to 1/8 pipe thread. Thats your last chance- beyond that,
you've run out of cast iron to screw around with and will need a new
caliper. Good luck- J Deryke
**************
Remember Mom this Mother's Day! Find a
florist near you now. (http://yellowpages.aol.com/search?query=florist&
ncid=emlcntusyelp00000006)
More information about the DeTomaso
mailing list