[DeTomaso] Help needed with clutch slave
MikeLDrew at aol.com
MikeLDrew at aol.com
Fri May 8 00:26:19 EDT 2009
In a message dated 5/7/09 21 22 26, chrisvkimball at msn.com writes:
> I just bled my new slave, and when I pushed the clutch down to see if it
> worked, it started to, then fluid shot out of the little valve. I don't
> want to overtighten it and break it off, or is my problem the bleed valve
> just isn't tight enough?
>
You got it!
Also, realize that whenever fluid is able to leak out, air is able to leak
IN, so you need to do a very thorough job of bleeding all the air out of the
system all over again. Use a six-sided box-end wrench (as opposed to a
12-point) to ensure maximum grip on the six flats on the bleeder nipple.
Good luck!
Mike
P.S. Remember that brake fluid will devour paint instantly, so don't let
that stuff spray around, and if it does happen to spill, wipe it up
immediately. :>)
**************
A Good Credit Score is 700 or Above. See yours in just
2 easy steps!
(http://pr.atwola.com/promoclk/100126575x1221322931x1201367171/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072&
hmpgID=115&bcd=May5509AvgfooterNO115)
More information about the DeTomaso
mailing list