[DeTomaso] Heater fan speeds
Dave Londry
davel at emspace.com
Mon May 4 23:18:16 EDT 2009
Thanks Charles.
Sounds like whenever you run low speed fan, you get a heater too.
That'd be OK in winter I guess, but with the AC on, low fan sounds like
a dumb idea.
When I do my wiring ripout I'll see if I can adapt a switching regulator
for the fan.
That would get rid of the resistor and give a variable-speed fan control.
dave
Charles Engles wrote:
> Dear Dave,
>
>
> Mike wrote:
> '
>
>> Can anyone tell me what the resistor value was and where it was located?
>> If I can't sort out the original connection I think I should be able to
>> switch the same R value into the full-speed line
>> and have it work the same as the original.
>>
>
> I don't know about its characteristics, but it's physical location is on
> the heater box itself.
> $$$$$$$ Yes, IIRC you need to remove the glove box for best access.
> The Stock resistor looks like it came out of 1917 rather than 1971.
> It is about 4 or 5 inches long and about 3/4" diameter on a ceramic
> base which also holds the heat shield over it.
>
> I remember Chuck Engles had some issues with his; it broke down and
> caused
> so much resistance that it caught fire!
> $$$$$$$ Ummm, no it did not catch fire, but it did glow red hot
> and release lots of smoke. It suddenly became obvious why it came
> with a formidable heat shield.
>
> If you're going to go through the trouble of sorting out the heater fan,
> you might as well replace the whole unit with a modern one. This
> incorporates the resistor inside the motor assembly itself, and it
> wires up directly to
> the switch. Typical units are three-speed, so you get to choose
> which two
> of the three speeds you use.
> $$$$$$$$ I finally got a replacement that worked, but the
> electrical wizards on the Forum have found at least two or three
> modern replacements that have to be way better than the funky stock
> resistor.
>
>
>
> Another incident of being electrically
> challenged, Chuck Engles (not on fire yet)
>
>
>
More information about the DeTomaso
mailing list