[DeTomaso] Banjo Fitting Washers and More
Brent Stewart
bjbstewart at yahoo.com
Tue Mar 24 14:06:15 EDT 2009
You're a life saver Bill! I just spoke with a Pantera Vendor that starts with a W, and they want $21 for those! Plus, their minimum charge with a Visa is $25!
address forthcoming...
brent
________________________________
From: "SOBill at aol.com" <SOBill at aol.com>
To: bjbstewart at yahoo.com; DeTomaso at realbig.com
Sent: Tuesday, March 24, 2009 10:54:47 AM
Subject: Re: [DeTomaso] Banjo Fitting Washers and More
Brent,
I have my front calipers apart. The OEM washers in mine are
copper.
The banjo fitting has two copper washers with a 10mm ID,a 15
mm OD, and a 1mm thickness.
Copper crush washers can be recylced by heating them red hot
with a propane torch and letting them air cool. Clean them up with a wire brush
and they are good for reuse.
The 7/16 inch ID (11.1mm) washers at http://www.pegasusautoracing.com/productselection.asp?Product=3241 should
work fine. Neither the ID, OD, or thickness are critical in this
application.
If you prefer, I have some 10mmID, 15.9mmOD, 1.7mm thick copper
washers which fit. Give me your address and how many you need and I'll mail
them to you ....... FREE! Can you beat that?
BTW, I also have brake fluid proof O-rings which seal the two sides
of the front OEM calipers. If anybody needs these O-rings, send my your
address.
Have fun,
SOBill
Taylor
sobill at aol.com
________________________________
Feeling the pinch at the grocery store? Make meals for under $10.
More information about the DeTomaso
mailing list