[DeTomaso] Winged Warrior Update

Dave Londry davel at emspace.com
Mon Jun 8 12:31:23 EDT 2009


The engine progress sounds pretty good.
Advance is all-in early, but I see the dawgvaggen is all in at 2,300 also.
Just remember - if you feel it refusing to rev (flattening out), get out 
of it.
dave

Dan Courtney wrote:
> Here's the latest on The Winged Warrior.
> The problems I've found so far are:
>
> Crack in coil wire boot at dist cap. Replaced.
> Excessive oil (WD40 - whoops) inside dist. cap. Cleaned.
> Possible low spark in #2 spark plug wire, suspected due to fouled plug. Replaced.
> Excessive fuel level, serious overflow. Float levels adjusted and elec fuel pump found to be pumping at an insanely high rate. Fuel pump adjustment screw appears to be missing. Regulator added.
> 3/4" crack at bottom of #5 header tube. Looking for welder.
>
> Also checked:
> Secondaries. Turns out they are vacuum operated. I'll be trying the paperclip test.
> Timing, 12 deg at idle, 32 total at aprox 2,300 rpm (testing curtailed early due to angry call from angry neighbor)
> Vacuum leaks with carb cleaner and soapy water. Nothing found and idle is great.
> Compression test, with engine warm. All 8 cylinders between 195 & 200 psi.
>
> Tomorrow I'll be taking it to the shop for a look at the pistons with another borescope and a dyno run to check the air/fuel and double check the timing.
>
> I'm not sure if any of the above caused the damage to the #5 & #6 spark plugs. Possibly the excessive fuel meeting air from the header crack and igniting in the exhaust, causing the backfiring I've been getting on deceleration.
> Or, it could be either the crack in the coil wire boot and/or oil in the dist cap causing cross-firing, and #5 & #6 are sequential in the firing order.
> They could also have been damaged on gapping, and the parts bounced around in the chamber.
>
> I also still have clutch issues. It looks like this new slave cylinder has gone bad already, as I'm losing fluid and gaining air. Also, the pedal still feels strange. Strong resistance but no action until the pedal is almost all the way up, then it just pops in, all of a sudden.
> I'm wondering if the throwout bearing is binding.
>
> Busted BIG or Reno!
>
> Dan
>
>
> Dan F. Courtney
>
> La Jolla, CA
>
> (858) 551-5455 Phone
> (858) 551-5456 Fax
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
>
>   

-- 
Dave Londry
Embedded Spaces Inc. (ESI)
davel at emspace.com

604 589 9183 phone/fax
604 721 2278 cell
Skype:embeddedspaces





More information about the DeTomaso mailing list