[DeTomaso] Comp Cam Kits

michael@michaelshortt.com michaelsavga at gmail.com
Thu Jul 30 12:09:36 EDT 2009


I have a Comp Cam, no problems at all, specs on my website

Michael Shortt
www.maichaelspantera.com

On Thu, Jul 30, 2009 at 11:59 AM, Thomas Borcich<tborcich at msn.com> wrote:
>
> Any one had experience with the Comp Cams kits. I'm finishing up my heads
> and need springs, keepers, retainers, teflon seals, pushrods, a timing set,
> studs, cam and lifters. Everything matched for $485 through Summit.
> They're Xtreme Energy are Hydralic Flat Tappet cam kits that looks pretty good.
> Any feedback on quality of their products?
>
> The one issue that I have is they have an LSA=110 on all their in stock Cleveland
> cams vs. 106 that Dan Jones suggests. Its only 4 degrees but the 106 brings
> the torque to a lower rpm...obviously a benefit for the cleveland. I'm going
> to check if they will make the cam with a specific grind.
>
> Regards,
>
>
> Tom
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>



-- 







Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you



More information about the DeTomaso mailing list