[DeTomaso] Front caliper bolt size?
Ken Green
kenn_green at yahoo.com
Fri Jul 17 09:37:37 EDT 2009
Chris,
I found this last night in Wilkinson's on-line catalog:
M6 X 1.0 X 10
Does that make any sense?
Ken
--- On Thu, 7/16/09, Chris Difani <cdifani at pacbell.net> wrote:
From: Chris Difani <cdifani at pacbell.net>
Subject: Re: [DeTomaso] Front caliper bolt size?
To: "Ken Green" <kenn_green at yahoo.com>, detomaso at realbig.com
Date: Thursday, July 16, 2009, 11:04 PM
Ken:
If memory serves, they are a "fine" thread 10MM, might even be an "extra fine". Either 10MM by 1.00MM, or maybe 10MM by .85MM. In any case it's a fine thread, or extra fine. If you don't mind waiting until tomorrow, I can trek out to the shop in the morning, and dig one of those bolts out. I know where they are (half the battle), and all I'll need to do is check their thread pitch.
Chris
Chris Difani
'73 L #5829 "LITNNG"
The Electric Pantera
Sacramento, CA
Email: cdifani at pacbell.net
________________________________________________________
----- Original Message -----
From: "Ken Green" <kenn_green at yahoo.com>
To: <detomaso at realbig.com>
Sent: Thursday, July 16, 2009 10:37 PM
Subject: [DeTomaso] Front caliper bolt size?
> Does anyone know the specs for the two bolts that mount the front calipers?
>
> Thanks,
>
> Ken
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list