[DeTomaso] Starter Studs
larry at ohiotimecorp.com
larry at ohiotimecorp.com
Sat Jul 4 11:31:03 EDT 2009
<<So the length increase either has to be in the middle, or the other end, or a combination
of the two>>
So your telling me that size does matter in ones stud?
Larry (studless) - Cleveland
On Sat Jul 4 11:24 , MikeLDrew at aol.com sent:
>
>In a message dated 7/4/09 7 56 57, forestg at att.net writes:
>
>
>> It doesn't really matter because the extra length should be in the
>> middle.
>>
>>>>But if it's not, potentially you could get a longer stud and not gain
>anything. For instance, the stock stud has 9mm of threads on one end, 17mm
>on the other end, and 9mm in the middle. If the new stud had 17mm on one
>end, 17mm on the other end, and 9mm in the middle, you would just thread it
>further into the hole but the business end (the end the starter slides over)
>wouldn't extend any further.
>
>So not only does the increased length matter, the *location* of the
>increase matters.
>
>
>> The short thread end should go into the bell housing.
>>
>>>>Thanks--that is what I expected too. So the length increase either has
>to be in the middle, or the other end, or a combination of the two.
>
>Thanks!
>
>Mike
>
>
>
>Make your summer sizzle with fast and easy recipes for the
>grill. (http://food.aol.com/grilling\?ncid=emlcntusfood00000005)
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list