[DeTomaso] Starter Studs
forestg at att.net
forestg at att.net
Sat Jul 4 10:56:29 EDT 2009
It doesn't really matter because the extra length should be in the middle. The short thread end should go into the bell housing.
Forest
-------------- Original message from MikeLDrew at aol.com: --------------
>
> In a message dated 7/3/09 22 52 54, asajay at asajay.com writes:
>
>
> >
> > Did you figure out the studs needed for the starter? I test fit mine
> > today and the studs are just a wee bit short. I could probably get a
> > nut on, but without a lock washer. With a lock washer, I'll be on just
> > a thread or two.
> >
> > Did you figure out the best choices? (sorry if I've not paid a lot of
> > attention, got beat up by a Mad Dog so I've been hiding my tail in the
> > garage the last couple of days.) :)
> >
>
> Larry Finch sent me the specs for his stock stud:
>
> ====
>
> M10 x 1.5
>
> The stock stud now in my hand is an overall length of 35mm.
>
> One end has about 9 mm of threads.
>
> Other end has about 17mm of threads
>
> Center section is about 9mm.
>
> New one needs to be longer.
>
> ====
>
> There you go. What Larry failed to tell me is WHICH end that is the end
> that the starter fits over, versus the end that goes into the bellhousing.
> For the end that the starter goes over is the end that has to be longer.
>
> Can you confirm?
>
> Mike
>
>
> **************
> Make your summer sizzle with fast and easy recipes for
> the grill. (http://food.aol.com/grilling?ncid=emlcntusfood00000005)
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list