[DeTomaso] DeTomaso Digest, Vol 60, Issue 3-HP gains

[Göran Malmberg]

Plasmacutter? Just buy a bit of sheet aluminium and use a band saw
to cut out an adapterplate. Look at http://www.hemipanter.se/ klick
"the engine" and you will see my plate on the hemi block.
Goran

-----Ursprungligt meddelande-----
Från: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com]
För RCBSONS1 at aol.com
Skickat: den 3 juli 2009 16:54
Till: detomaso at realbig.com
Ämne: Re: [DeTomaso] DeTomaso Digest, Vol 60, Issue 3-HP gains

The engine builder for my Monster Pontiac motor
used straight 40 weight for the dyno run.... 755 hp
He claims that after break-in I can change to Lighter
synthetic oil and I will pick up 40 Hp... this is one of his
smaller motors at 500 inches... he builds a lot of mountain
motors at 735 inches and 1400 to 1600 hp
Maybe I should transplant this into my Pantera
Now I wonder were I would get a bellhousing
I guess we could get the plasma cutter and welder out
I think this motor is really on the edge with 777 lift and triple
springs
 
Bob Benson
**************A Good Credit Score is 700 or Above. See yours in just 2
easy 
steps! 
(http://pr.atwola.com/promoclk/100126575x1222585087x1201462804/aol?redir
=http://www.freecreditreport.com/pm/default.aspx?sc=668072&hmpgID=62&bcd
=
JulystepsfooterNO62)
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
Checked by AVG - www.avg.com 
Version: 8.5.375 / Virus Database: 270.13.2/2215 - Release Date:
07/02/09 18:06:00