[DeTomaso] Fw: Mallory Dist

[Tomas Gunnarsson]

In the link I sent earlier there are suggestions (in the tips and facts section) for what voltage you should have at idle. If what you measure is different from that I'd be inclined to bypass the resistance loom and use only the Mallory resistor.

Tomas

----- Original Message ----- 
From: "Will Demelo" <wdemelo at cogeco.ca>
To: <detomaso at realbig.com>
Sent: Sunday, January 18, 2009 2:35 PM
Subject: [DeTomaso] Fw: Mallory Dist


> Do I need to/should I  use a ballast resistor (it currently has one ) with 
> a Mallory distributor if I have a 74 L with the resistance loom wiring from 
> factory?
> Will
> ----- Original Message ----- 
> From: "Will Demelo" <wdemelo at cogeco.ca>
> To: <detomaso at realbig.com>
> Sent: Saturday, January 17, 2009 2:28 PM
> Subject: [DeTomaso] Mallory Dist
> 
> 
>> I'm not getting the cam signal from my Mallory distributor to my FAST ecu.
>> How do I check if the Mallory module is working? I've got 12v going in. 
>> Should I see a light in the module?
>> Will
>> _______________________________________________
>>
>> Detomaso Forum Managed by POCA
>>
>> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>>
>> DeTomaso mailing list
>> DeTomaso at list.realbig.com
>> http://list.realbig.com/mailman/listinfo/detomaso 
> 
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> 
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
> 
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso