[DeTomaso] Cam change and Vacuum Advance distributor

[Göran Malmberg]

A hotter cam may like a little more initial advance.
Goran
----- Original Message ----- 
From: "Thomas Borcich" <tborcich at msn.com>
To: "Pantera REALBIG forum" <detomaso at realbig.com>
Sent: Friday, February 27, 2009 3:35 PM
Subject: [DeTomaso] Cam change and Vacuum Advance distributor


>
> Gentlemen, I'm doing a cam change and still have the stock vacuum advance
> distributor. Dan Jones suggested to change to Mallory Ingition Module. I 
> was
> curious, once you change the cam to higher performance specs as follows
> should anything be done to the distributor advance since vacuum will 
> change:
>
> 228/232 degrees @ 0.050" lift (280/284 @ 0.006"),
> 0.588"/0.588" lift,
>
> 107 LSA, 68 degrees overlap, installed in the engine on a 104 intake
>
> centerline.
> Should I trash the stock distributor or have it recurved or leave it 
> alone?
>
> The slope now is completely covered with ice...I'm sliding faster than 
> ever.
>
> Best regards,
>
> Tom Borcich
>
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>