[DeTomaso] ZF ring-gear safety wire
JDeRyke at aol.com
JDeRyke at aol.com
Sun Feb 8 23:37:26 EST 2009
In a message dated 2/8/09 1:33:43 PM, davel at emspace.com writes:
snip......
> My great plan to inspect 6143 for safety wire using a borescope though the
> drainhole didn't work out. I just can't flex the fibre sharply enough to get
> to the backside of the ring-gear.
>
Maybe not if you have a small enough borescope, or are really limber.... I
tried this on the bench and it worked so its worth a try since you seem
reluctant to pull the ZF on speculation. What you do is double-nut one of the upper
sidecover studs and remove it. Then stick your borescope thru the not-quite-3/8"
dia hole and inspect the ring gear. I used a peanut light bulb to illuminate
the inside of the case and by getting my eyeball close to the hole, I was able
to see the backside of the ring gear. Remember, the preferred wire size is
0.032" stainless, but I had a '69 Mangusta ZF that was wired with 0.060" wire-
good for bridges and locomotives. Good luck- J Deryke
**************
A Good
Credit Score is 700 or Above. See yours in just 2 easy steps!
(http://pr.atwola.com/promoclk/100000075x1218550342x1201216770/aol?redir=http://www.freecreditreport
.com/pm/default.aspx?sc=668072%26hmpgID=62%26bcd=febemailfooterNO62)
More information about the DeTomaso
mailing list