[DeTomaso] NPC - RE: Lug Bolts
Tomas Gunnarsson
guson at home.se
Tue Dec 1 14:19:15 EST 2009
Google "bmw m12x1.25x42" and you'll get a bunch of hits. There should be no reason to custom make them.
Tomas
----- Original Message -----
From: "Dave Londry" <davel at emspace.com>
To: <unlisted-recipients:>; <no To-header on input>
Cc: "DeTomaso Mail List" <detomaso at realbig.com>
Sent: Tuesday, December 01, 2009 4:46 AM
Subject: [DeTomaso] NPC - RE: Lug Bolts
> Thanks everybody who passed along a suggestion. I'd better tell the story.
>
> The lug bolt is:
> M12 x 1.25 for 24 mm,
> M17 unthreaded for 17 mm
> Conical taper to 22 mm with a 19 mm hex head cut in it.
>
> It was made in a Dunlop Wheel Plant in Coventry,
> which has since been closed and hauled off to India.
> There ain't none.
>
> I thought maybe I could find an 11/16 truck lug with a conical taper,
> and then get a set of them cut down to M12 and just wear out some M12
> fine dies on them.
> Couldn't find that either.
>
> I could do a CAD drawing of the part, but having somebody cut that from
> bar stock
> would probably cost as much as a set of wheels. (Should be Grade 5 at
> least)
>
> So look what a world of crap a little inattention can get you into.
>
> Larry - could you cook me up a little closing line for the situation?
> dave
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list