[DeTomaso] NPC- Ruger Mark II .22 Question
JDeRyke at aol.com
JDeRyke at aol.com
Mon Aug 31 00:41:02 EDT 2009
In a message dated 8/29/09 1:12:19 PM, michaelsavga at gmail.com writes:
> Any other mods?
>
Tapered barrels screw off or on with some difficulty since the taper is
hard to grip without scarring, and barrels are available in various lengths,
designs and materials. If you buy a non-Ruger-made barrel, the thread-grip
length may have to be adjusted a bit to get the integral front sight to wind up
at the top of the barrel, but this is not difficult. Thus a less-desirable
4-1/2" barrel length assembly can become a 6" or (more) barrel assembly at
less than retail prices. Contoured hand-grips are easy to fabricate, too. The
website <www.AuctionArms.com> is a reliable source of spares. Good luck- J
Deryke
More information about the DeTomaso
mailing list