[DeTomaso] Clutch Slave Adjustment
Julian Kift
julian_kift at hotmail.com
Wed Aug 19 18:31:30 EDT 2009
Rather than rely on external length which tells you very little about the internal size, it would be easier to measure bore diameter as long throws have a reduced bore size so that the same volume of fluid from the master moves the slave through a longer action.
Julian
> From: JDeRyke at aol.com
> Date: Wed, 19 Aug 2009 18:08:21 -0400
> To: asajay at asajay.com; detomaso at realbig.com
> Subject: Re: [DeTomaso] Clutch Slave Adjustment
>
> In a message dated 8/19/09 2:41:42 PM, asajay at asajay.com writes:
>
> > I also think I -might- have a long throw slave, but don't really know how
> > to tell.
> >
> Many (but not all) long throw slaves are stainless; if the thing is
> non-magnetic, likely it's a long-throw. Or, you could measure the cylinder's \
> length; stock is 3.675" from back end to front of cylinder (under the boot).
> Someone on the list could measure their known-long throw for you. Cheers- J
> Deryke
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
_________________________________________________________________
Hotmail® is up to 70% faster. Now good news travels really fast.
http://windowslive.com/online/hotmail?ocid=PID23391::T:WLMTAGL:ON:WL:en-US:WM_HYGN_faster:082009
More information about the DeTomaso
mailing list