[DeTomaso] Shock tower crossmember measurement

[Larry - Ohio Time Corp]

Hi Tom,

I cleaned up some of the factory drawings for my friends in Tx a number of
years ago. They may help you.

http://www.spacecitypanteras.com/Technical/chassis_diagrams.htm

Larry - Cleveland


-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of Thomas Borcich
Sent: Sunday, August 02, 2009 2:58 PM
To: Pantera REALBIG forum
Subject: [DeTomaso] Shock tower crossmember measurement


Guys, can anyone give me the standard measurement for the rear crossmember
shock tower? Pocket end to pocket end? 
My bolt holes are very elongated on both sides, actually look like ovals.
I'm sending my car
off this week to have the wheel house damage repaired from broken half
shafts and would like
to have the crossmember bolted in relatively close to a stock measurement
before the welding starts. 
I have a December 72 build car.

Thanks

Tom 

_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso