[DeTomaso] half shafts and u joints
JDeRyke at aol.com
JDeRyke at aol.com
Mon Apr 20 13:27:18 EDT 2009
When I said the two halves should be at 90 degrees to each other, I meant
the crosses should be parallel. If you assemble the halfshafts and set them
on the ground, the crosses should be flat to each other- one should NOT be
cocked at all. This is much harder to explain than to do!
Some halfshafts are indeed balanced with welded washers. But in fact, the
halfshafts are small in diameter so the amount of imbalance is not very much
and all the parts are quite close to the center of rotation. You have 3
choices: assemble and drive: if you feel any excessive vibration at high speeds,
you'll have to do something. If not, you lucked out. Or you can try
interchanging the pieces until the vibration goes away. Third choice is to take the
halfshafts to a driveline specialist shop and they will re-balance the
parts. Once you have them so there's no vibration, metal-stamp the pieces so
this doesn't happen again. Good luck- J Deryke
**************
Access 350+ FREE
radio stations anytime from anywhere on the web. Get the Radio Toolbar!
(http://toolbar.aol.com/aolradio/download.html?ncid=emlcntusdown00000003)
More information about the DeTomaso
mailing list