[DeTomaso] two questions
bill gaino
gaino at earthlink.net
Wed Apr 8 08:08:07 EDT 2009
Scuff and clean the tube, silicone works, make sure the tube has a bolt holding it in. 750 sounds right for 408 ci. Try 76 jets in the primary and 78 in the secondary.
-----Original Message-----
>From: Christopher Kimball <chrisvkimball at msn.com>
>Sent: Apr 7, 2009 1:19 PM
>To: Pantera List Serve <detomaso at realbig.com>
>Subject: [DeTomaso] two questions
>
>
>Hi everyone.
>
>
>
>I have two questions for you prior to my new motor going in:
>
>
>
>1) I was told to get an O ring for my dipstick tube (at the bottom when it goes into the new engine block). The folks at NAPA had no idea what I was talking about, and when I called a Pantera vendor, the guy there said they use a brass washer crimped at the base of the tube as a stop, then seal it with silicone.
>
>
>
>Since I don't have one of the little brass things, he said I could just use that gasket-type silicone to seal the tube where it enters the engine block, and no O ring was necessary.
>
>
>
>What say y'all?
>
>
>
>2) My engine will be a bored and stroked Cleveland block displacing 408 CI. The carb shop said a Holley 750 would be a good match for the kind of driving I do (mainly street). I have edelbrock heads, if that matters.
>
>
>
>Do you agree with the carb recommendation?
>
>
>
>Thanks,
>
>
>
>Chris
>
>
>
>
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list