[DeTomaso] sway bar bushings
JDeRyke at aol.com
JDeRyke at aol.com
Wed Sep 24 13:52:23 EDT 2008
In a message dated 9/24/08 3:49:58 AM, justingreisberg at hotmail.com writes:
> On my very original 74 GTS, the rear bar was not 3/4" but just a tad bigger
> - metric. It sure looks like the stock bar. The 3/4" poly bushings I
> bought did not fit well, but could be squeezed in, BUT the spherebar thingies from
> Dennis in Colorado had to be reamed out by me to fit - a real pain in the
> a--. I can not believe I am the only car to have this issue.
>
GTS bars were the metric equivalent of 7/8" which aided handling. All U.S-
made aftermarket bars are either painted or plated. In a POCA article last year,
I mentioned that Hall's Sphere-ball outboard ends must fit the bar very
tightly but still be free to slide back & forth, or you lose effectiveness in the
system. I found if the bar in question is plated, the bushings will need
reaming to the thickness at least of the plating. My black-painted OEM GTS bar slid
right in with no reaming but the pretty plated bar needed reaming. FWIW- J
Deryke
**************
Looking for simple solutions to your real-life financial
challenges? Check out WalletPop for the latest news and information, tips and
calculators.
(http://www.walletpop.com/?NCID=emlcntuswall00000001)
More information about the DeTomaso
mailing list