[DeTomaso] cooler air to carb

michael at michaelshortt.com michael at michaelshortt.com
Fri Oct 10 14:16:14 EDT 2008


Same as used on many cars like my 944, a simple ducted route to unheated air
that is sucked in by the induction system only.
It works or they wouldn't do it at Porsche.

Michael in Savannah

On Fri, Oct 10, 2008 at 2:07 PM, Tomas Gunnarsson <guson at home.se> wrote:

> Richard,
>
> I took a stock aircleaner in rough shape and modified it. I made a new
> snout to match the original aircleaner hole that went from a rectangular
> cross section to a round cross section. I then bought flex hose as used for
> kitchen fans (i.e. it doesn't burn easily) and routed it towards the ground.
> At "ground level" I simply made a short tube to clamp the hose to and bolted
> the tube to the chassis. No scoop, no flaring, just a straight cut tube end
> that points to the ground. I also filled the vacuum operated port and
> duplicated the snout/hose installation on the drivers side of the car. My
> air cleaner air temp is marginally above ambient at speed. All this is
> barely visible standing behind the car looking into the engine bay and to
> the unknowing appears stock.
>
> Tomas
>
> ----- Original Message -----
> From: <RKMosier at aol.com>
> To: <michael at michaelshortt.com>
> Cc: <detomaso at realbig.com>
> Sent: Friday, October 10, 2008 7:32 PM
> Subject: [DeTomaso] cooler air to carb
>
>
> > We have talked in the past about the gill area and air flow over them and
> > scoops and such.  Is the feeling that area is a negative pressure  area?
>  What I
> > am wondering is if you drew air through vents there, without  scoops
> would it
> > be drawn into the air filter/carb at speed or would it be a  negative
> > situation and actually be bad and reduce air to the carb when at  spped?
>  In stop and
> > go traffic I assume it would be cooler air than that in  the engine
> > compartment but could be bad a speed?
> >
> > I am just wondering if there is a easy (a relative term) to get air
> cooler
> > that the hot engine bay air into the carb without changing the lines and
> design
> > of the car like scoops on the roof or gill area.
> >
> > This would not reduce the circulation in the engine compartment of
>  course.
> > For that you would have to vent like the fans on the grill over  the
> engine as
> > someone showed us pictures months back had done.
> >
> > Perhaps I am going over old ideas.
> >
> > Richard
> > 3714 72 Pre L
> > **************New MapQuest Local shows what's happening at your
> destination.
> > Dining, Movies, Events, News & more. Try it out
> > (http://local.mapquest.com/?ncid=emlcntnew00000002)
> > _______________________________________________
> >
> > Detomaso Forum Managed by POCA
> >
> > Archive Search Engine Now Available at http://www.realbig.com/detomaso/
> >
> > DeTomaso mailing list
> > DeTomaso at list.realbig.com
> > http://list.realbig.com/mailman/listinfo/detomaso
>



-- 
Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you



More information about the DeTomaso mailing list