[DeTomaso] Engine/ZF pull - instructions & recommendations?

[cengles at cox.net]

Dear Erik,

I highly recommend the procedure detailed on Chuck Melton's site, ProvoMo.. I printed it off about eight or nine years ago and have had reason to use it, oh, four or five times (!!), I always refer back to it now from time to time. I can't recall any deficiencies. It is excellent and highly recommended.

I will send you some pictures later of an attachment you can fabricate to ease the process.


Warmest regards, Chuck Engles


---- Erik Anderson <eanderson at geotracinternational.com> wrote:
>Hello all.
>
>Well, I think I made my last drive yesterday up here in Alberta. The
>weather has been fantastic but I can smell frost in the air.
>
>So ... I am now looking for detailed instructions for pulling my
>power-plant. I want to take both the Cleveland and ZF out together. My
>first order of business is to service my fuel cell, which is badly
>rusted inside.
>
>With the bay empty, I also plan on cleaning up the firewall, upgrading
>(where needed) my wiring, clips, hoses, etc. A chassis rigidity kit is
>also part of the plan.
>
>Re: pulling the power-plant and fuel cell, I am looking for as much
>detail as possible, including pictures. That said, if you have any
>other suggestions, I am all ears ...
>
>Thanks in advance,
>
>EA
>#3528
>
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso