[DeTomaso] Rear Axles

[bill gaino]

use the laws of phicis'  Object in motion, tends to stay in motion...put the right Hand thread on the RR   facing in it holds and if it faced out it would spin off..  Use a lock nut device anyway... HMMM?

-----Original Message-----
>From: MikeLDrew at aol.com
>Sent: May 24, 2008 4:51 PM
>To: SOBill at aol.com, jtaphorn at kingwoodcable.com, detomaso at realbig.com
>Subject: Re: [DeTomaso] Rear Axles
>
>
>In a message dated 5/24/08 16 46 3, SOBill at aol.com writes:
>
>
>> At
>> _http://www.panterasbywilkinson.com/webpages/catalog/extra/ill02_07.html?prod
>> _id=01200b_
>> (http://www.panterasbywilkinson.com/webpages/catalog/extra/ill02_07.html?prod
>> _id=01200b)  it  says RH axle shaft stamped D and LH axle shaft
>> stamped S.
>> 
>
>Ah yes, but the question is deeper than that.   The RH *thread* axle shaft is 
>stamped D and the LH *thread* axle shaft is stamped S.   But, does the RH 
>thread axle on on the right, or left side of the car?
>
>That is the unknown at this point.   Anybody?
>
>Mike
>
>
>**************
>Get trade secrets for amazing burgers. Watch "Cooking with 
>Tyler Florence" on AOL Food.
>      (http://food.aol.com/tyler-florence?video=4&
>?NCID=aolfod00030000000002)
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso