[DeTomaso] TRIPLE DISC CLUTCH????
MikeLDrew at aol.com
MikeLDrew at aol.com
Sat May 10 02:08:30 EDT 2008
In a message dated 5/9/08 23 03 57, johnmckee at cox.net writes:
> Were you using the Pantera specific Dual Friction Centerforce assembly?
>
And much more importantly, are you *sure* you had it adjusted correctly?
Even a little bit of pressure on the throwout bearing caused by an improperly
adjusted slave cylinder would cause the clutch to slip (and drastically shorten
the life of the throwout bearing). Before going any further (and more
importantly, before spending any more money), absolutely ensure that there is
adequate freeplay in the clutch mechanism.
Although the Pantera Centerforce clutch is a 10.5 inch unit (the stock clutch
is 11 inches), I seriously doubt that it's incapable of withstanding the
torque that your motor is putting out. If it's not misadjusted, could there be
an oil leak (either from engine or gearbox) or some other problem?
Mike
**************
Wondering what's for Dinner Tonight? Get new twists on
family favorites at AOL Food.
(http://food.aol.com/dinner-tonight?NCID=aolfod00030000000001)
More information about the DeTomaso
mailing list