[DeTomaso] Heater valve Rebuild
Charles Engles
cengles at cox.net
Thu Mar 13 21:57:29 EDT 2008
Dear Clay,
When I rebuilt my valves ages ago, I seem to recall that all
that was needed was an o ring, which was available locally at the Ace
Hardware store. I don't know of a rebuild kit and I doubt that one exists,
as "rebuilding" it is basically a simple disassemble-clean- replace O
ring-add waterproof grease and reassemble process. I will see if I can
find the tech article on rebuilding them and send it to you.
Warmest regards, Chuck Engles
----- Original Message -----
From: "clay willmott" <claywillmott at hotmail.com>
To: <detomaso at realbig.com>
Sent: Thursday, March 13, 2008 8:46 PM
Subject: [DeTomaso] Heater valve Rebuild
Anyone know off hand where the rubber o ring gasket and internal
plastic/rubber stopper can be purchased or is it easier to get a new heater
valve? I thought there may be a rebuild kit available.
My heater valve has FORD stamped on it and part numbers 67 PG and 8495A-A.
Thanks
Clay
_________________________________________________________________
Climb to the top of the charts! Play the word scramble challenge with star
power.
http://club.live.com/star_shuffle.aspx?icid=starshuffle_wlmailtextlink_jan
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
--
No virus found in this incoming message.
Checked by AVG.
Version: 7.5.518 / Virus Database: 269.21.7/1327 - Release Date: 3/12/2008
1:27 PM
More information about the DeTomaso
mailing list