[DeTomaso] Breakin lube
JDeRyke at aol.com
JDeRyke at aol.com
Thu Mar 13 14:51:02 EDT 2008
In a message dated 3/12/08 2:05:34 PM, wdemelo at cogeco.ca writes:
> What is recommended for lifter/cam lube during installation?
>
Coat each lifter and cam lobe with some sort of high-load grease (NOT chassis
grease!). I use Isky Cam Lube which looks like a moly-paste but may have
extra stuff in it as well. Use plenty; most cam lobe/lifter failures occur in the
1st 5 minutes of running a new cam & lifters. If using stock valves, also use
a stock cam, lifters & springs, all of which combine to valve-float at rpms
below that which normally causes valve failure. Or throw in a rev-limiter set
to about 5200 rpms and warn your customer not to change chips without
chaniging all the other stuff.Good luck- J DeRyke
**************
It's Tax Time! Get
tips, forms, and advice on AOL Money & Finance.
(http://money.aol.com/tax?NCID=aolprf00030000000001)
More information about the DeTomaso
mailing list